Pert Multi Sensor is a Wi-Fi enabled device to control the IR remote based appliances. All appliances can be remote controlled by only one smart phone. It has got 3 Home monitoring sensors like Temperature, luminosity and smoke which helps your monitor and protect your house. Supports home appliances like TV, Set-Top Box, Air-conditioning, Loudspeaker Box, Motor Curtain. Multi Sensor Includes : A) IR SENSOR Pert Multi sensor has 7 IR transmitters inside the box. This IR sensor covers 300Sq feet area in a closed room. Pert Multi Sensor has an IR receiver inside the box. By using this receiver, the user can program the remotes in to the sensor. B) TEMPERATURE SENSOR Pert Multi Sensor has a Temperature sensor at the bottom of side behind the enclosure.It senses the temperature from 2°C to 150°C with a 0.1°C resolution. The error percentage is 2% on the nominal value. C) GAS SENSOR Pert Multi sensor has a gas sensor placed inside the enclosure. The gas sensor detects even a sensitive material like SnO2, which is detected when there is lower conductivity in clean air. When the target combustible gas exits the sensor, the conductivity is high and the gas concentration rises. The Gas sensor is highly sensitive to LPG, Propane gas and Hydrogen. The gas sensor also detects the smoke when it is enters the enclosure. D) LIGHT SENSOR PERT Multi Sensor is has a light sensor on the back side bottom. This sensor senses the light and displays the value in lux (Units of luminance). Infrared Transmitting Material Reduce the infrared diffuse reflection Infrared transmittance rate Beautiful and unique design Fashionable and Elegant Outline the beauty of art Petals Shape Emission Light Multiple Levels Launch Guarantee each order will be sent quickly and accurately INSTALLATION The Wi-Fi signal should be greater than 75% at Pert Sensor installation location. Insert the input AC cable into any 3 Pin 6A Plug Point. Please note, this should be in the IR range (i.e: 300 sq ft from the appliances) Switch on the Pert device and Press the Smartconfig button located on behind of the device. The Led turns to Red color and the device is ready to configure, and can be configured manually like any other Pert device from the mobile app. After the configuration is complete, the user can control the IR devices from the PERT mobile application (with the available remotes) Please note: If your remote is not available in the PERT remote library then you can add a remote.